Field Notice: FN - 72242 - Limited Number of Cisco Catalyst IR1100 Rugged Series Routers Might Fail to Boot When Upgrading to Cisco IOS XE 17.5.1 - Software Upgrade Recommended

Available Languages

Updated:September 8, 2021

Document ID:FN72242

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Notice

THIS FIELD NOTICE IS PROVIDED ON AN "AS IS" BASIS AND DOES NOT IMPLY ANY KIND OF GUARANTEE OR WARRANTY, INCLUDING THE WARRANTY OF MERCHANTABILITY. YOUR USE OF THE INFORMATION ON THE FIELD NOTICE OR MATERIALS LINKED FROM THE FIELD NOTICE IS AT YOUR OWN RISK. CISCO RESERVES THE RIGHT TO CHANGE OR UPDATE THIS FIELD NOTICE AT ANY TIME.

Revision History

Revision	Publish Date	Comments
1.0	07-Sep-21	Initial Release

Products Affected

Affected Product ID	Comments
IR1101-K9	Only when upgrading to Cisco IOS XE 17.5.1
IR1101-A-K9	Only when upgrading to Cisco IOS XE 17.5.1

Defect Information

Defect ID	Headline
CSCvz36477	IR1101: some devices fail to boot with no error messages

Problem Description

Cisco Catalyst IR1100 Rugged Series Routers with pluggable modems inserted might fail to boot the image during the upgrade to Cisco IOS^® XE Release 17.5.1.

Background

Cisco Catalyst IR1100 Rugged Series Routers with pluggable modems inserted might fail to boot the image during the upgrade to Cisco IOS XE Release 17.5.1. This issue often occurs without any additional messages displayed on the console.

Note: One of these messages might be displayed:

Occasionally, the message “Watchdog timeout” might be displayed, or
The message "EFI stub: Exiting boot services and installing virtual address map..." might be displayed and after a few minutes the system returns to ROM Monitor (ROMMON).

Problem Symptom

This issue occurs when a Cisco Catalyst IR1100 Rugged Series Router with pluggable modems inserted is upgraded to Cisco IOS XE Release 17.5.1

Two symptoms for this issue are:

When an IR1101 router boots Cisco IOS XE Release 17.5.1, it will display these messages to the console, stall for a couple of minutes, and return to ROMMON.

Image validated
WATCHDOG: Armed to 171798 milliseconds
MCU Watchdog is enabled
EFI stub: Booting Linux Kernel...
EFI stub: Using DTB from configuration table
EFI stub: Exiting boot services and installing virtual address map...

When an IR1101 router boots Cisco IOS XE Release 17.5.1, it will dump a kernel panic call trace to the console and return to ROMMON.

Kernel panic - not syncing: SBSA Generic Watchdog timeout
CPU: 0 PID: 0 Comm: swapper/0 Tainted: G           O    4.14.200-17.0.2 #1
Hardware name: Cisco sparrow (DT)
Call trace:
 dump_backtrace+0x0/0x168
 show_stack+0x24/0x30
 dump_stack+0xb8/0x100
 panic+0x12c/0x2a0
 sbsa_gwdt_interrupt+0x18/0x20 [sbsa_gwdt]
...

Workaround/Solution

Solution

The customer must upgrade to Cisco IOS XE Release 17.6.1a.

Workaround

The customer can remove the pluggable modem and power-cycle (that is, disconnect the power cord and reconnect) the device to bring up the Cisco IOS XE Release 17.5.1 image. It is possible that reinserting the pluggable modem might result in the device again failing to boot.

For More Information

If you require further assistance, or if you have any further questions regarding this field notice, please contact the Cisco Systems Technical Assistance Center (TAC) by one of the following methods:

Receive Email Notification For New Field Notices

My Notifications—Set up a profile to receive email updates about reliability, safety, network security, and end-of-sale issues for the Cisco products you specify.