Monitoring the Power System in the Cisco cBR Chassis
Monitoring the Power System in the Cisco cBR Chassis Using LEDs
|
LED |
Status |
Description |
|---|---|---|
|
POWER ENABLE LED |
Green |
The chassis power is on. |
|
Off |
The chassis power is off. |
 Note |
VER 01 of the AC FPEM has P0 AC PRESENT LED through P5 AC PRESENT LED. The PRESENT LEDs indicate input AC power for the corresponding AC Power Modules (also indicated on the front of the Power Module). Updated AC FPEM started shipping from April, 2018. |
|
LED |
Status |
Description |
||
|---|---|---|---|---|
|
POWER ENABLE LED |
Green |
The chassis power is on. |
||
|
Off |
The chassis power is off. |
|||
|
DC PRESENT LED |
Green |
The DC power input is present.
|
||
|
Yellow |
The DC power input is reversed. |
|||
|
Off |
The DC power input is not present. |
|
LED |
Status |
Description |
|---|---|---|
|
Input power LED |
Green |
AC input voltage is present and within the correct range. |
|
Blinking |
AC input voltage is present and out of the acceptable range. |
|
|
Off |
AC input voltage is not present. |
|
|
Output power LED |
Green |
The Power Module output voltage is on. |
|
Blinking |
The AC Power Module is in a power limit or overcurrent condition. |
|
|
Off |
The AC Power Module output voltage is off. |
|
|
Fault LED |
Red |
Internal fault in the AC Power Module. |
|
Off |
The AC Power Module is operating normally. |
|
LED |
Status |
Description |
|---|---|---|
|
Input power LED |
Green |
Dual DC input voltages are present and within the correct range (-40 V to -72 V). |
|
Blinking |
The DC Power Module is in single input operation mode and at least one DC input voltage is out of the acceptable range. |
|
|
Off |
Dual DC input voltages are less than -26 V (or is less than -26 V for a single input operation mode). |
|
|
Output power LED |
Green |
The DC Power Module output voltage is on. |
|
Blinking |
The DC Power Module is in a power limit or overcurrent condition. |
|
|
Off |
The DC Power Module output voltage is off. |
|
|
Fault LED |
Red |
Internal fault in the DC Power Module. |
|
Off |
The DC Power Module is operating normally. |
Monitoring the Power System in the Cisco cBR Chassis Using CLI
show environment power —Displays the power consumption for each card and the power output for each Power Module. Following is a sample output:
Router# show environment power
------------------------------
Slot Controller Value
------------------------------
3 FRU Power 340 W
P0 PEM Power 275 W
P1 PEM Power 220 W
P2 PEM Power 220 W
R0 FRU Power 410 W
Feedback