The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
To configure an On-Demand Routing (ODR) process on a Cisco router, use the router odr command in global configuration mode. To disable the ODR process, use the no form of this command.
router odr
no router odr
This command has no arguments or keywords
No default behavior or values
Global configuration
The router odr command is used to configure a router as an ODR hub router to dynamically accept routes from stub peers. ODR provides IP routing with minimal configuration requirements. The overhead of dynamic routing protocol is avoided without incurring the configuration and management overhead of static routing.
The ODR process maintains a routing table, which is populated with information learned from ODR stub peers. Cisco Discovery Protocol (CDP) must be enabled on the hub router and stub peers. ODR timing values should be tuned based the number of peers and the speed of the links in your network. Route filtering should be applied consistently.
In the following example, an ODR process is enabled, a distribution list is configured to filter routes learned from ODR stub peers, and redistribution statement is configured under the Open Shortest Path First (OSPF) routing process:
Router(config)# access-list 101 permit ip host 10.0.0.1 192.168.1.0 0.0.0.255
Router(config)# access-list 101 permit ip 10.0.10.2 255.0.0.0 192.168.2.0 0.0.0.255
Router(config)# router odr
Router(config-router)# distribute-list 101 in
Router(config-router)# exit
Router(config-router)# router ospf 1
Router(config-router)# redistribute odr subnets
To adjust On-Demand Routing (ODR) network timers, use the timers basic command in router configuration mode. To restore default ODR timer values, use the no form of this command.
timers basic update invalid holddown flush [sleeptime]
no timers basic
ODR uses the following default values if this command is not configured or if the no form of this command is entered:
update: 90 seconds
invalid: 270 seconds
holddown: 280 seconds
flush: 630 seconds
sleeptime: 0 milliseconds
Router configuration
The basic timing parameters for ODR are adjustable. Because this routing protocol is executing a distributed, asynchronous routing algorithm, it is important that these timers be the same for all routers and access servers in the network.
Note The current and default timer values are displayed in the output of the show ip protocols EXEC command. The relationships of the various timers should be preserved as described in the syntax description table.
In the following example, updates are configured to be broadcast every 5 seconds. If a reply is not received from a peer within 15 seconds, the route is declared unusable. Further information the dead peer is suppressed for an additional 15 seconds. At the end of the suppression period, the route is flushed from the routing table.
Router(config)# router odr
Router(config-router)# timers basic 5 15 15 30
Router(config-router)# end
Note When configuring a short update period, you run the risk of congesting slow-speed serial lines; however, this is less of a concern on high-speed links, such as Fast Ethernet, Gigabit Ethernet, and T1-rate serial links. Also, if you have many routes in your updates, you can cause the routers to spend an excessive amount of time processing updates.
|
|
---|---|
cdp timer |
Specifies how often the Cisco IOS software sends CDP updates, |
router odr |
Configures an ODR process on a Cisco router. |