- A
- B
- cac master through call application stats
- call application voice through call denial
- call fallback through called-number (dial peer)
- caller-id (dial peer) through ccm-manager switchover-to-backup
- ccs connect (controller) through clear vsp statistics
- clid through credentials (sip-ua)
- default (auto-config application) through direct-inward-dial
- disable-early-media through dualtone
- E
- F
- G
- H
- icpif through irq global-request
- isdn bind-l3 through ixi transport http
- K
- L
- map q850-cause through mgcp package-capability
- mgcp persistent through mmoip aaa send-id secondary
- mode (ATM/T1/E1 controller) through mwi-server
- N
- O
- package through pattern
- periodic-report interval through proxy h323
- Q
- R
- sccp through service-type call-check
- session through sgcp tse payload
- show aal2 profile through show call filter match-list
- show call history fax through show debug condition
- show dial-peer through show gatekeeper zone prefix
- show gateway through show modem relay statistics
- show mrcp client session active through show sip dhcp
- show sip service through show trunk hdlc
- show vdev through show voice statistics memory-usage
- show voice trace through shutdown (voice-port)
- signal through srv version
- ss7 mtp2-variant through switchover method
- target carrier-id through timeout tsmax
- timeouts call-disconnect through timing clear-wait
- timing delay-duration through type (voice)
- U
- vad (dial peer) through voice-class sip encap clear-channel
- voice-class sip error-code-override through vxml version 2.0
- W
- Z
Notes
This document contains Cisco IOS commands that are supported in many different software releasesand on many different platforms. Some of the commands that are included in this document may not besupported in your Cisco IOS software release.
Any Internet Protocol (IP) addresses used in thisdocument are not intended to be actual addresses. Any examples, command display output, and figuresincluded in the document are shown for illustrative purposes only. Any use of actual IP addressesin illustrative content is unintentional and coincidental.
Recommended Reading:
About Cisco IOS SoftwareDocumentation
Using theCommand-Line Interface in Cisco IOS Software
Feedback