L Commands
This chapter describes the Cisco NX-OS commands that begin with L that are used to manage a Cisco Nexus 2000 Series Fabric Extender from a Cisco Nexus 5000 Series switch.
locator-led fex
To turn on the locator LED of a Fabric Extender, use the locator-led command. To turn off the locator LED, use the no form of this command.
Syntax Description
Command Default
Command Modes
Command History
|
|
---|---|
Note On a Cisco Nexus 5000 Series switch that runs a Cisco NX-OS release prior to 4.1(3)N1(1), the locator beacon LED was toggled with the beacon command. |
Usage Guidelines
Use the locator-led command to toggle the locator LED of a Fabric Extender, which allows you to easily identify the machine in a busy data center.
The locator-led command replaces the following command, which is deprecated in Cisco NX-OS Release 4.1(3)N1(1) and later releases:
Examples
This example shows how to turn on the locator LED for a specific Fabric Extender chassis:
This example shows how to turn off the locator beacon LED for a specific Fabric Extender chassis:
Related Commands
|
|
---|---|
Displays all configured Fabric Extender chassis connected to the switch. |
|
Displays the status of the locator LED in Fabric Extender modules. |
logging fex
To set the logging alert level for Fabric Extender events, use the logging fex command. To reset the logging level, use the no form of this command.
logging fex [ severity-level ]
no logging fex [ severity-level ]
Syntax Description
(Optional) Number of the desired severity level at which messages should be logged. Messages at or numerically lower than the specified level are logged. Severity levels are as follows: |
Command Default
Command Modes
Command History
|
|
Examples
This example shows how to set the logging alert level for Fabric Extender events:
switch(
config)#
logging fex 4
This example shows how to reset the logging level:
switch(
config)#
no logging fex
Related Commands
|
|
---|---|
Displays all configured Fabric Extender chassis connected to the switch. |