Troubleshooting BGP [IP Routing]

Document ID: 22166

PDF Downloads

Interactive: This document offers customized analysis of your Cisco device.

Introduction
Before You Begin
      Conventions
      Prerequisites
      Components Used
Main Troubleshooting Flowchart
Troubleshooting BGP Neighbor Establishment
Troubleshooting Routes Missing from the Routing Table
Troubleshooting Multihoming Inbound
Troubleshooting BGP Route Advertisement
Troubleshooting Multihoming Outbound
Related Information

Introduction

This document provides troubleshooting information for common problems with Border Gateway Protocol (BGP). To see more information, or to go to the next flowchart, click the command boxes in red.

If you have the output of a show ip bgp , show ip bgp neighbors , show ip bgp summary , or show tech-support command from your Cisco device, you can use Output Interpreter (registered customers only) to display potential issues and fixes. To use Output Interpreter (registered customers only) , you must be a registered customer, be logged in, and have JavaScript enabled.

Before You Begin

Conventions

For more information on document conventions, see the Cisco Technical Tips Conventions.

Prerequisites

There are no specific prerequisites for this document.

Components Used

This document is not restricted to specific software and hardware versions.

The information presented in this document was created from devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If you are working in a live network, ensure that you understand the potential impact of any command before using it.

Main Troubleshooting Flowchart

Troubleshooting BGP Neighbor Establishment

Note: *Sample log messages to be checked when neighbor is not coming up:

BGP_SESSION-5-ADJCHANGE: neighbor[ip address] IPv4 Unicast topology base removed
  from session Peer closed the session
BGP_SESSION-5-ADJCHANGE: neighbor[ip address] IPv4 Unicast topology base removed
  from session Unknown path error

Note: **Example of ping with packet size and enable does not fragment bit in IP header:

Router#ping 10.10.10.2 size 1400 df-bit

Type escape sequence to abort.
Sending 5, 1400-byte ICMP Echos to 10.10.10.2, timeout is 2 seconds:
Packet sent with the DF bit set
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/37/84 ms

IP Routing