Guest

Cisco WAN Switching Modules

IGX 8400 BTM and NTM Trunk Error Definitions and Troubleshooting Information

Hierarchical Navigation

Downloads

Document ID: 8608


Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Trunk Error Definitions
Cisco Support Community - Featured Conversations
Related Information

Introduction

This document defines trunk errors reported by the Cisco IGX 8400 Series Switch broadband trunk module (BTM) and the network trunk module (NTM) for Cisco WAN Switching System Software (SWSW) Release 9.2 and later.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on these software and hardware versions:

  • BTM

  • NTM

  • Cisco WAN SWSW Release 9.2 and later

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Trunk Error Definitions

Refer to these documents to access information about the various trunk error definitions and troubleshooting information for SWSW Release 9.2 and later:

Note: Trunk errors reported by the NTM are similar to those reported by the IPX network trunk card (NTC) for switch software release 9.1 and earlier. The IPX is not supported by SWSW Release 9.2 and later.

Cisco Support Community - Featured Conversations

Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers. Below are just some of the most recent and relevant conversations happening right now.

 

Related Information

Updated: Apr 17, 2009Document ID: 8608