Cisco Compatible Micro Router Series

F0

IPX Not Installed.

F1

IPX Not Installed.

F2

No DOS Memory.

F3

No Free ECB (can't allocate memory).

F4

Lock Failed.

F5

Over the Maximum Limit (CompatiView Error).

F6

IPX Previously Initialized (CompatiView Error).

FF9B

An unknown error occured attempting to load the WinSock library.

276C

The WinSock library is an unsupported version. The WinSock library must support WinSock version 1.1.

FF94

The WinSock library doesn't support large enough packets for CompatiView. The library must support UDP packets of at least 618 bytes.

FF98

CompatiView unable to allocate sufficient memory.

F0 (240)

IPX Not Installed.

F1 (241)

IPX Not Initialized (CompatiView Error).

FA (250)

No Local Target Identified. CompatiView was unable to find a route to the selected router.

FE (254)

Socket table Full.

FF (255)

Socket Already Open.

FF96

IP Transport not active.

FF99

CompatiView out of connection resources.

276D

WinSock not initialized (CompatiView error).

2742

Network down.

273F

Address family not supported (CompatiView error).

2734

Blocking sockets operation in progress (CompatiView error).

2728

Out of file descriptors (CompatiView error).

2747

No socket buffer space is available.

273B

Protocol not supported (CompatiView error).

2739

Specified protocol doesn't match socket (CompatiView error).

273C

Socket type not supported for this address family (CompatiView error).

88

This usually happens when the router does not have enough buffer space available to hold the downloaded information plus whatever information it needs to store from Flash ROM. Try restarting the router.

89

This means that a login attempt has failed. CompatiView normally traps this error return so the user is unlikely to ever see it.

90

Error writing tunnel config

91

Error writing filter config

92

Error writing sys information config

93

This usually happens when the router restarts in the middle of a download. A very slow link or many lost packets can cause this situation. This error can also occur if a download is attempted while another download is still being processed. Another condition where the router will return this error is if the wrong software is downloaded to the router.

94

The code download failed a checksum calculation. This is usually due to a corrupted file being downloaded to a router. Try FTPing it in binary mode.

101

Failed allocation of supplement config area

102

Failed allocation of code area

103

Failed allocation of zone area

104

Failed allocation of config area

105

Unkown administration code