Document ID: 108876
Contents
Introduction
How do I check the HTTP configuration of the switch?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. How do I check the HTTP configuration of the switch?
A.Note: If you can ping the switch but unable to access it's Web-UI, check the HTTP Configuration by following the steps below.
Checking the HTTP Configuration of the Switch
Step 1:
Access the switch's configuration interface via HyperTerminal or Telnet.Step 2:
Go to the System Configuration Menu and select IP Configuration.
Step 3:
Under IP Configuration select HTTP Configuration. Make sure HTTP Server is set to ENABLE and HTTP Server Port is set to 80.
Step 4:
Go back to the IP Configuration menu and select HTTPS Configuration. Make sure HTTPS Server Port is set to 443.
Step 5:
Try accessing the switch's web-based setup page by typing "http://192.168.1.254".
Related Information
| Updated: Dec 12, 2008 | Document ID: 108876 |