Document ID: 109163
Contents
Introduction
What lights are available on the front of the device?
Related Information
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. What lights are available on the front of the device?
A.
SRW224
The Switch's LEDs and ports are located on the front panel.
LEDs
System - (Green) Lights to indicate the power is being supplied to the Switch.
LINK/ACT - (Green) Lights to indicate a functional network link through the corresponding port (1-24) with an attached device. The LED blinks to indicate that the Switch is actively sending or receiving data over that port.
Ports
LAN (1-24) - The LAN (Local Area Network) ports connect to Ethernet network device, such as other switches or routers.
Gigabit1/Gigabit2/miniGBIC - The switch is equipped with two Gigabit ports and a mini GBIC port that is shared with Gigabit port 2. If Gigabit port 2 is being used, the miniGBIC port cannot be used. They link to high-speed network peripheral system or clients at speeds of up to 1000Mbps.
Gigabit - (Green) Lights to indicate the port is working in Gigabit mode.
Console - The Console port is where you connect a serial cable from a PC's serial port.
Related Information
| Updated: Dec 12, 2008 | Document ID: 109163 |