Cisco Access Registrar

Document ID: 6329

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Edit the RexAcctScript
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

This document explains how to manually edit the Cisco CNS Access Registrar RexAcctScript so that your accounting log files reflect a CSV-format.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on Cisco CNS Access Registrar versions 1.7 and 3.0.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Edit the RexAcctScript

If you want your accounting log files to reflect a CSV-format that can be used in your billing applications, edit the RexAcctScript manually and recompile it. The file is located by default at $ARINSTALLPATH/examples/rexacctscript/AcctAsScript.cpp.

To change the format of the accounting, make the changes shown in this table:

Note: " " contains a space.

For you compile and install the RexAcctScript script, use gcc 2.95-3. For additional details, refer to Cisco CNS Access Registrar User's Guide - Using the REX Accounting Script.

The output of the accounting file needs to look something like this:

Tue, 26 Sep 2000 17:15:22 
User-Name = sven, NAS-IP-Address = 10.200.68.2, NAS-Port = 2, Service-Type = NAS Prompt, 
Calling-Station-Id = 172.17.246.244, Acct-Status-Type = Start, Acct-Delay-Time = 0, 
Acct-Session-Id = 0000000D, Acct-Authentic = RADIUS, NAS-Port-Type = Virtual,,,,, 
Tue, 26 Sep 2000 17:15:23 User-Name = sven, NAS-IP-Address = 10.200.68.2, NAS-Port = 2, 
Service-Type = NAS Prompt, Calling-Station-Id = 172.17.246.244, Acct-Status-Type = Stop, 
Acct-Delay-Time = 0, Acct-Session-Id = 0000000D, Acct-Authentic = RADIUS, 
Acct-Session-Time = 1, Acct-Terminate-Cause = User Request, NAS-Port-Type = Virtual,,,,,

The accounting files now contain a comma (",") between each entry.

NetPro Discussion Forums - Featured Conversations

Related Information

• Cisco CNS Access Registrar Support Page
• Documentation for Cisco CNS Access Registrar
• Technical Support - Cisco Systems