Cisco DSL Router Configuration and Troubleshooting Guide - PPPoA Implementation Options

Available Languages

Download Options

  • PDF     (5.6 KB)
    View with Adobe Reader on a variety of devices
Updated:September 20, 2006
Document ID:71111

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document discusses the Point-to-Point Protocol over ATM (PPPoA) implementation options.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Options

Select one of these PPPoA implementation options for your Asymmetric Digital Subscriber Line (ADSL) service. Both implementation options include configuration examples for Network Address Translation (NAT) overload, NAT Pool, Static NAT, and Dynamic Host Control Protocol (DHCP) Server.

Select the option that describes the type of PPPoA service your ISP provides.

  • PPPoA Option 1—Your ISP assigns a single dynamic public IP address to your Cisco DSL Router.

  • PPPoA Option 2—Your ISP assigns a single static public IP address to your Cisco DSL Router.

Return to the Main Page of this configuration guide.

Verify

There is currently no verification procedure available for this configuration.

Troubleshoot

There is currently no specific troubleshooting information available for this configuration.

Related Information

Revision History

Revision Publish Date Comments
1.0
20-Sep-2006
Initial Release

Was this Document Helpful?

FeedbackFeedback

Contact Cisco