PDF(137.7 KB) View with Adobe Reader on a variety of devices
Updated:April 12, 2012
Document ID:1518624797009383
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
EOL7273
Cisco announces the end-of-sale and end-of life dates for the Cisco 880 Integrated Services Router for Small Offices - Cisco 887 ADSL Router. The last day to order the affected product(s) is December 20, 2011. Customers with active service contracts will continue to receive support from the Cisco Technical Assistance Center (TAC) as shown in Table 1 of the EoL bulletin. Table 1 describes the end-of-life milestones, definitions, and dates for the affected product(s). Table 2 lists the product part numbers affected by this announcement. For customers with active and paid service and support contracts, support will be available until the termination date of the contract, even if this date exceeds the Last Date of Support shown in Table 1.
Table 1. End-of-Life Milestones and Dates for the Cisco 880 Integrated Services Router for Small Offices-Cisco 887 ADSL Router
Milestone
Definition
Date
End-of-Life Announcement Date
The date the document that announces the end of sale and end of life of a product is distributed to the general public.
December 20, 2010
End-of-Sale Date
The last date to order the product through Cisco point-of-sale mechanisms. The product is no longer for sale after this date.
December 20, 2011
Last Ship Date: HW
The last-possible ship date that can be requested of Cisco and/or its contract manufacturers. Actual ship date is dependent on lead time.
March 19, 2012
End of SW Maintenance Releases Date: HW
The last date that Cisco Engineering may release any final software maintenance releases or bug fixes. After this date, Cisco Engineering will no longer develop, repair, maintain, or test the product software.
December 19, 2013
End of Routine Failure Analysis Date: HW
The last-possible date a routine failure analysis may be performed to determine the cause of hardware product failure or defect.
December 19, 2012
End of New Service Attachment Date: HW
For equipment and software that is not covered by a service-and-support contract, this is the last date to order a new service-and-support contract or add the equipment and/or software to an existing service-and-support contract.
December 19, 2012
End of Service Contract Renewal Date: HW
The last date to extend or renew a service contract for the product.
March 19, 2016
Last Date of Support: HW
The last date to receive service and support for the product. After this date, all support services for the product are unavailable, and the product becomes obsolete.
December 31, 2016
HW = Hardware OS SW = Operating System Software App. SW = Application Software
Table 2. Product Part Numbers Affected by This Announcement
End-of-Sale Product Part Number
Product Description
Replacement Product Part Number
Replacement Product Description
Additional Information
CISCO887-K9
Cisco 887 ADSL2/2+ Annex A Router
CISCO887VA-K9
Cisco 887 VDSL/ADSL over POTS Multi-mode Router
-
CISCO887-SEC-K9
Cisco 887 ADSL2/2+ Annex A Sec Router w/ Adv IP
CISCO887VA-SEC-K9
Cisco 887 VDSL/ADSL over POTS Multi-mode Router w/ Adv IP
-
CISCO887G-K9
887G ADSL2/2+ AnnexA Sec Router w/ Ad.IP, 3G Global GSM/HSPA
C887VAG+7-K9
VDSL2/ADSL2+ over POTS (non-US) 3.7G HSPA+ R7 w/ SMS/GPS
See the Product Migration Options section below for detailed information on replacing this product.
CISCO887GW-GN-E-K9
Cisco 887 ADSL2/2+ Annex A Router w/ 3G 802.11n ETSI Comp
See the Product Migration Options section below for detailed information on replacing this product.
CISCO887MW-GN-E-K9
Cisco 887 ADSL2/2+ Annex M Router 802.11n ETSI Comp
See the Product Migration Options section below for detailed information on replacing this product.
CISCO887W-GN-A-K9
Cisco 887 ADSL2/2+ Annex A Router 802.11n FCC Comp
See the Product Migration Options section below for detailed information on replacing this product.
CISCO887W-GN-E-K9
Cisco 887 ADSL2/2+ Annex A Router 802.11n ETSI Comp
See the Product Migration Options section below for detailed information on replacing this product.
Product Migration Options
Customers are encouraged to migrate to the Cisco 880VA Series Integrated Services Routers. The Cisco 880VA Series routers deliver advanced features and benefits and increased performance, and they support DSL multimode, very-high-bit-rate DSL 2 (VDSL2) and asymmetric DSL 2+ (ADSL2+) on a single WAN interface. Information about this product can be found at:
http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78-613481.html. The Cisco 880VA Series with third-generation (3G) wireless WAN is scheduled to be released in April 2011,and the series with the latest 802.11n WLAN capability is scheduled to be released in July 2011.
Customers may be able to use the Cisco Technology Migration Program (TMP) where applicable to trade-in eligible products and receive credit toward the purchase of new Cisco equipment. For more information about Cisco TMP, customers should work with their Cisco Partner or Cisco account team. Cisco Partners can find additional TMP information on Partner Central at
http://www.cisco.com/web/partners/incentives_and_promotions/tmp.html
Customers may be able to continue to purchase the Cisco 880 Integrated Services Router for Small Offices-Cisco 887 ADSL Router through the Cisco Certified Refurbished Equipment program. Refurbished units may be available in limited supply for sale in certain countries on a first-come, first-served basis until the Last Date of Support has been reached. For information about the Cisco Certified Refurbished Equipment program, go to:
http://www.cisco.com/go/eos
Service prices for Cisco products are subject to change after the product End of Sale date.
The Cisco Takeback and Recycle program helps businesses dispose properly of surplus products that have reached their end of useful life. The program is open to all business users of Cisco equipment and its associated brands and subsidiaries. For more information, go to:
http://www.cisco.com/web/about/ac227/ac228/ac231/about_cisco_takeback_recycling.html
Any authorized translation issued by Cisco Systems or affiliates of this end-of-life Product Bulletin is intended to help customers understand the content described in the English version. This translation is the result of a commercially reasonable effort; however, if there are discrepancies between the English version and the translated document, please refer to the English version, which is considered authoritative.
Feedback