Tidal Enterprise Orchestrator: Use Tasks in the Web Console

Available Languages

Updated:September 17, 2011
Document ID:113233

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes how to use tasks in the Tidal Enterprise Orchestrator (TEO) web console.

Prerequisites

Requirements

This document requires that you have a general knowledge of TEO tasks and the TEO web console.

Components Used

The information in this document is based on TEO 2.1 or later.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

TEO Web Console

The TEO web console is a lighter UI that allows a user to look at tasks assigned to them and to run processes ad-hoc.

How to Use Tasks

Complete these steps:

  1. Open your TEO web console and go to the My Tasks page.

    Note: You will only see tasks assigned to you or your group. If you do not know how to assign tasks, refer to the TEO documentation or contact support.

  2. On the My Tasks page, you will see all tasks that are assigned to you. At the top of the page, you can also select whether to see those that are only open tasks or all tasks (including closed tasks). In order to open the task, click the web link for each task on the left side.

  3. After you open the task, you can interact with the task, change the status, and view things like the automation summary.

  4. This web console setup with tasks allows you to serve a larger user base and still use their input and interaction with the TEO server.

Related Information

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products