Tidal Enterprise Scheduler: How to Turn Off Fault Tolerance on the Database

Available Languages

Updated:July 26, 2011
Document ID:113135

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

This document describes how to turn off Fault Tolerance on the database.

Prerequisites

Requirements

The procedure described in this document requires the assistance of a qualified DBA with access to the Scheduler database. (For Oracle this is the ‘tidal’ schema. For SQL Server, this is the ‘Admiral’ database.) Cisco recommends that you back up your database before you complete the procedure described in this document and before you run any SQL commands against the database.

Components Used

The information in this document is based on these software and hardware versions:

  • Cisco Tidal Enterprise Scheduler release 5.3.1.x

  • SQL Database 2005-2008

  • Oracle 10g-11g SQL*Plus

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for information on document conventions.

Procedure

In order to turn off fault tolerance on the database, complete these steps:

  1. Access the Scheduler database from SQL*Plus or SQL Server Management Studio.

  2. Run this command:

    UPDATE sysval SET sysval_string = 'N' WHERE (sysval_id=21);

Related Information

Was this Document Helpful?

FeedbackFeedback

Contact Cisco