Routing Information Protocol (RIPv2) Properties Configuration on SG500X Series Stackable Switches

Available Languages

Download Options

PDF (287.9 KB)
View with Adobe Reader on a variety of devices
ePub (339.7 KB)
View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle) (159.1 KB)
View on Kindle device or Kindle app on multiple devices

Updated:December 13, 2018

Document ID:SMB2869

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Routing Information Protocol (RIPv2) Properties Configuration on SG500X Series Stackable Switches

Objective

Routing Information Protocol (RIP) is a distance-vector protocol for local and wide-area networks. It classifies routers as either active or passive. Active routers advertise their routes to others while passive routers listen to other devices, and update their routes based on advertisements, but do not advertise. Routers typically run RIP in active mode while hosts use passive mode. RIP is an Interior Gateway Protocol (IGP).

RIPv2 is an enhancement of RIPv1. RIPv2 is a classless protocol and RIPv1 is a class based protocol. RIPv2 has password authentication while RIPv1 does not have password authentication. RIPv2 uses multicast and RIPv1 uses broadcast.

This article explains how to configure RIPv2 properties on the SG500X Series Stackable Switches.

Applicable Devices

• SG500X Series Stackable Switches

Software Version

• 1.2.7.76

RIPv2 Properties Configuration

Step 1. Log in to the web configuration utility, and choose IP Configuration > RIPv2 > RIPv2 Properties. The RIPv2 Properties page opens:

Step 2. Check the Enable check box to enable RIP on the switch.

Step 3. Check Enable in the Redistribute Static Route field to allow static routes to be redistributed by RIP. Redistribution is necessary in a network that runs more than one routing protocol. More than one routing protocol on a network is necessary when two companies running different routing protocols merge, or when different departments are handled by different network administrators. If this feature is enabled, rejected routes are advertised by routes with a metric of 16. The metric in RIP is based upon the hop count, which is the total number of devices the data will pass through. The maximum hop count that the RIP routes travels is 15, so the metric of 16 means that the route is unreachable.

Step 4. Click the radio button that corresponds with the desired static metric type in the Redistribute Static Metric field.

• Transparent — RIP uses the routing table metric for the propagated static route configuration.

• Default Metric — Enter the metric value for the propagated static route configuration. The metric is based upon the hop count, which is the total number of devices the data can pass through.