View Etherlike Statistics on Sx500 Series Stackable Switches

Objectives

Switches provide access to Etherlike statistics. These statistics are information related to errors at the physical layer such as hardware related errors. These errors can occur due to failures in essential network component such as copper cables, interfaces, and Network Interface Cards (NICs). In case of a connectivity problem, these statistics can be helpful in determine the cause of the problem. This article explains the information on the Etherlike page on Sx500 Series Stackable Switches.

Applicable Devices

• Sx500 Series Stackable Switches

Software Version

• 1.3.0.62

View Etherlike Statistics

Step 1. Log in to the web configuration utility and choose Status and Statistics > Etherlike. The Etherlike page opens:

Step 2. Click the radio button of one of the available types of interface in the Interface field. The available types of interfaces are:

• Port — Choose from the Port drop-down list the physical port you wish to view Etherlike statistics from.

• LAG — Choose from the Link Aggregation Group (LAG) drop-down list the LAG port you wish to view Etherlike statistics from. A LAG port is a logical port that combines the capabilities of multiple physical ports to provide more bandwidth.

Step 3. Click one of the available radio buttons to refresh the Etherlike statistic information in the Refresh Rate field. The available options are:

• No Refresh — The Etherlike page never refreshes.

• 15 sec — Refreshes the Etherlike page every 15 seconds.

• 30 sec — Refreshes the Etherlike page every 30 seconds.

• 60 sec — Refreshes the Etherlike page every 60 seconds.

The Etherlike page displays the following Etherlike statistics on the chosen interface:

• Frame Check Sequence (FCS) Errors — Displays received frames that failed the Cyclic Redundancy Check (CRC). CRC detects whether a frame arrived to the destination in the correct order. Each frame carries a CRC number which is tested upon arrival to the destination. If the CRC numbers match between the frames, then the packet contains no errors. If not, then the packet is corrupted and then it is dropped.

• Single Collision Frames — The number of frames that were involved in a single collision, but eventually successfully transmitted.

• Late Collisions — The number of collisions that have been detected after the first 512 bits of data.

• Excessive Collisions — The number of transmissions that were rejected due to excessive collisions.

• Oversize Packets — The number of packets received that were greater than 2000 octets.

• Internal MAC Receive Errors — The number of frames rejected due to errors on the receiver.

• Pause Frames Received — The number of received flow control pause frames.

• Pause Frames Transmitted — The number of flow control pause frames transmitted.

Step 4. (Optional) Click Clear Interface Counters to clear the Etherlike statistics counters on the chosen interface.

Step 5. (Optional) Click Clear All Interface Counters if you want to clear the Etherlike statistics counters on all the interfaces.