Single Point Setup Sessions on WAP551 and WAP561 Access Points

Objective

The Single Point Setup is used to control the wireless service across multiple devices. It is used to create a cluster of wireless devices, once the cluster is created then other wireless access points can join the cluster. After the cluster is completed all the devices share their information such as VAP settings, QoS and radio parameters to reduce interference and maximize the bandwidth of the network.

The Sessions page displays information of the clients associated with the WAP device. The clients are identified by the device location and device MAC address. This article shows the clients information in the cluster on the WAP551 and WAP561 access points.

Note: To enable Single Point Setup refer article Single Point Setup Configuration on WAP551 and WAP561 Access Points.

Applicable Devices

• WAP551
• WAP561

Software Version

• 1.0.4.2

Single Point Setup Sessions

Step 1. Log in to the web configuration utility and choose Single Point Setup > Sessions. The Sessions page opens:

The information displayed is:

• AP Location — The location of the access point.

• User MAC — The MAC address of the client.

• Idle — The amount of time the device was inactive.

• Rate (Mbps) — The rate at which the information is shared among the WAP devices.

• Signal — The strength of the signal that the client receives from the AP.

• Rx Total — Number of packets received by the client.

• Tx Total — Number of packets transmitted by the client.

• Error Rate — Number of times the frames where dropped at data transmission on the AP.

Step 2. (Optional) To display specific information, choose the desired information from the Display drop-down list and click Go. The Client Information is displayed.