When a user tries to call another remote user that is registered to another Cisco Unified Callmanager Express, the called party name appears as To fake_Display on the calling phone display while the call is connected. This document describes how to troubleshoot this issue.
Cisco recommends that you have knowledge of Cisco Unified Callmanager Express.
The information in this document is based on Cisco Unified Callmanager Express Version 4.1(0).
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
When a user tries to call another remote user that is registered to another Cisco Unified Callmanager Express, the called party name appears as To fake_Display on the calling phone display while the call is connected.
This issue is documented in Cisco bug ID CSCsi69413 (registered customers only) , which is fixed in IOS software versions 12.4XC and later.
This error message appears on the remote side phones because the terminating gateway sends an alert message, instead of a progress message, after it receives a call setup message. This happens if the command voice call send-alert is enabled on the Cisco Unified Callmanager Express installed router.
In order to resolve this issue, use the no voice call send-alert command. The terminating gateway will send a progress message after it receives a call Setup message.
Revision | Publish Date | Comments |
---|---|---|
1.0 |
24-Mar-2009 |
Initial Release |