Introduction
This document describes how to enable HTTPS access for the Cisco Unity Express (CUE) GUI.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
- Cisco Unity Express
- HTTPS
Components Used
The information in this document is based on Cisco Unity Express version 8 and later.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
How do I enable HTTPS access for the CUE GUI?
Complete these steps in order to enable HTTPS access for the CUE GUI:
- In CUE CLI config mode, run the crypto key generate rsa label gui modulus 1024 command.
- Reload CUE.
- In CUE CLI config mode, run the web session security keyLabel gui command.
- Enable Transport Layer Security (TLS) 1.0 in Microsoft Internet Explorer and Mozilla Firefox.
- In the browser address bar, enter https://<cue-ip-address> OR http://<cue-ip-address>:443.