Troubleshooting Multi-Site and Multi-Pod
This section describes how to troubleshoot Multi-Site and Multi-Pod.
Error:400
If you receive the following error:
Error:400 - Invalid Configuration Following Intersite Spines are not configured as Mpod Spines: 1202
You must enable the fabric external connectivity for all the existing spines and if you are trying to add new spines use the Setup Multipod GUI wizard.
There are two ways to resolve this issue.
-
Enable all the spines under the external routed network:
-
In the APIC GUI, on the menu bar, click
. -
In the Navigation pane, expand , right-click on the external routed network and choose Enable Fabric External Connectivity.
-
-
Add new spines under the external routed network:
-
In the APIC GUI, on the menu bar, click Fabric.
-
In the Navigation pane, expand and complete the Multipod setup.
-