The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Ethernet and virtual Ethernet commands that begin with R.
To set the packet per second (PPS) rate limit for an interface, use the rate-limit cpu direction command. To revert ot the default value, use the no form of this command.
rate-limit cpu direction { both | input | output } pps pps_value action log
no rate-limit cpu direction { both | input | output } pps pps_value action log
Specifies the packets per second. The range is from 0 to 100,000. |
|
Writes a syslog message if the PPS value matches or exceeds the specified rate limit. |
|
|
---|---|
This example shows how to set the maximum input packet rate to 3 for an interface and enable the logging of syslog messages:
|
|
---|---|
To configure the hostname for the remote machine, use the remote hostname command. To revert to the default settings, use the no form of this command.
remote hostname host-name [ port port-num ] [ vrf { vrf-name | default | management }]
SVS connection configuration mode
|
|
---|---|
This example shows how to configure the hostname for a remote machine:
This example shows how to remove the hostname configuration for a remote machine:
|
|
---|---|
Configures the virtual routing and forwarding (VRF) instance for a remote machine. |
|
To configure the IPv4 address for the remote machine, use the remote ip address command. To revert to the default settings, use the no form of this command.
remote ip address ipv4-addr [ port port-num ] [ vrf { vrf-name | default | management }]
SVS connection configuration mode
|
|
---|---|
This example shows how to configure the IPv4 address for a remote machine:
This example shows how to remove the IPv4 address configuration for a remote machine:
|
|
---|---|
Configures the virtual routing and forwarding (VRF) instance for a remote machine. |
|
To configure the TCP port of the remote machine, use the remote port command. To revert to the default settings, use the no form of this command.
TCP port of the remote host. The port number is from 1 to 65355. |
SVS connection configuration mode
|
|
---|---|
This example shows how to configure the TCP port of a remote machine:
This example shows how to remove the TCP port configuration of a remote machine:
|
|
---|---|
Configures the virtual routing and forwarding (VRF) instance for a remote machine. |
|
To configure the virtual routing and forwarding (VRF) instance for the remote machine, use the remote vrf command.
remote vrf { vrf-name | default | management }
VRF name. The name is case sensitive and can be a maximum of 32 characters. |
|
SVS connection configuration mode
|
|
---|---|
This example shows how to configure the VRF of a remote machine:
|
|
---|---|
To set the revision number for the Multiple Spanning Tree (MST) region configuration, use the revision command. To return to the default settings, use the no form of this command.
Revision number for the MST region configuration. The range is from 0 to 65535. |
|
|
---|---|
Two or more switches with the same VLAN mapping and name are considered to be in different MST regions if the configuration revision numbers are different.
This example shows how to set the revision number of the MST region configuration:
switch(config)#
spanning-tree mst configuration
switch(
config-mst)#
revision 5
|
|
---|---|