The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Border Gateway Protocol (BGP) commands that begin with E.
To configure the exterior Border Gateway Protocol (eBGP) time-to-live (TTL) value to support eBGP multihop, use the ebgp-multihop command. To return to the default setting, use the no form of this command.
TTL value for eBGP multihop. The range is from 2 to 255. You must manually reset the BGP sessions after using this command. |
BGP neighbor configuration mode
|
|
---|---|
Use the ebgp-multihop command to configure the eBGP time-to-live (TTL) value to support eBGP multihop. In some situations, an eBGP peer is not directly connected to another eBGP peer and requires multiple hops to reach the remote eBGP peer. You can configure the eBGP TTL value for a neighbor session to allow these multihop sessions.
This example shows how to configure the eBGP multihop value:
|
|
---|---|