To display configuration information about virtual
interfaces, perform one of the following tasks:
Command
|
Purpose
|
switch#
show interface
vfc
vfc-id
|
Displays the detailed configuration of
the specified Fibre Channel interface.
|
switch#
show interface
brief
|
Displays the status of all interfaces.
|
switch#
show vlan fcoe
|
Displays the mapping of FCoE VLANs to VSANs.
|
This example shows how to display a
virtual Fibre Channel interface bound to an Ethernet interface:
switch# show interface vfc 3
vfc3 is up
Bound interface is Ethernet1/37
Hardware is Virtual Fibre Channel
Port WWN is 20:02:00:0d:ec:6d:95:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is F, FCID is 0x490100
Port vsan is 931
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
Interface last changed at Thu May 21 04:44:42 2009
This example shows how to display a virtual Fibre Channel
interface bound to a MAC address:
switch# show interface vfc 1001
vfc1001 is down
Bound MAC is 00:0a:00:00:00:01
Hardware is Virtual Fibre Channel
Port WWN is 23:e8:00:0d:ec:6d:95:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 901
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
This example shows how to display the status of all the
interfaces on the switch (some output has been removed for brevity):
switch# show interface brief
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
fc3/1 1 auto on trunking swl TE 2 --
fc3/2 1 auto on sfpAbsent -- -- --
...
fc3/8 1 auto on sfpAbsent -- -- --
-------------------------------------------------------------------------------
Interface Status IP Address Speed MTU Port
Channel
-------------------------------------------------------------------------------
Ethernet1/1 hwFailure -- -- 1500 --
Ethernet1/2 hwFailure -- -- 1500 --
Ethernet1/3 up -- 10000 1500 --
...
Ethernet1/39 sfpIsAbsen -- -- 1500 --
Ethernet1/40 sfpIsAbsen -- -- 1500 --
-------------------------------------------------------------------------------
Interface Status IP Address Speed MTU
-------------------------------------------------------------------------------
mgmt0 up 172.16.24.41 100 1500
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
vfc 1 1 F -- down -- -- --
...
This example shows how to display the mapping between the
VLANs and VSANs on the switch:
switch# show vlan fcoe
VLAN VSAN Status
-------- -------- --------
15 15 Operational
20 20 Operational
25 25 Operational
30 30 Non-operational