bridge |
Generates STP bridge MIB traps. |
cluster |
Generates a trap when the cluster configuration changes. |
config |
Generates a trap for SNMP configuration changes. |
copy-config |
Generates a trap for SNMP copy configuration changes. |
cpu threshold |
Allow CPU-related traps. |
entity |
Generates a trap for SNMP entity changes. |
envmon |
Generates environmental monitor traps. You can enable any or all of these environmental traps: fan, shutdown, status, supply, temperature. |
flash |
Generates SNMP FLASH notifications. In a switch stack, you can optionally enable notification for flash insertion or removal, which would cause a trap to be issued whenever a switch in the stack is removed or inserted (physical removal, power cycle, or reload). |
fru-ctrl |
Generates entity field-replaceable unit (FRU) control traps. In the switch stack, this trap refers to the insertion or removal of a switch in the stack. |
hsrp |
Generates a trap for Hot Standby Router Protocol (HSRP) changes. |
ipmulticast |
Generates a trap for IP multicast routing changes. |
mac-notification |
Generates a trap for MAC address notifications. |
ospf |
Generates a trap for Open Shortest Path First (OSPF) changes. You can enable any or all of these traps: Cisco specific, errors, link-state advertisement, rate limit, retransmit, and state changes. |
pim |
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can enable any or all of these traps: invalid PIM messages, neighbor changes, and rendezvous point (RP)-mapping changes. |
port-security |
Generates SNMP port security traps. You can also set a maximum trap rate per second. The range is from 0 to 1000; the default is 0, which means that there is no rate limit.
Note
| When you configure a trap by using the notification type port-security, configure the port security trap first, and then configure the port security trap rate: |
snmp-server enable traps port-security
snmp-server enable traps port-security trap-rate rate
|
snmp |
Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link up or link down. |
storm-control |
Generates a trap for SNMP storm-control. You can also set a maximum trap rate per minute. The range is from 0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every occurrence). |
stpx |
Generates SNMP STP Extended MIB traps. |
syslog |
Generates SNMP syslog traps. |
tty |
Generates a trap for TCP connections. This trap is enabled by default. |
vlan-membership |
Generates a trap for SNMP VLAN membership changes. |
vlancreate |
Generates SNMP VLAN created traps. |
vlandelete |
Generates SNMP VLAN deleted traps. |
vtp |
Generates a trap for VLAN Trunking Protocol (VTP) changes. |