The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter contains the following topics:
Cisco IMC Supervisor 2.0 is available only as an appliance. You cannot upgrade from version 1.0 or 1.1 version of Cisco IMC Supervisor to version 2.0 using the upgrading process. You must first install the 2.0 version and then migrate all the data from an earlier installed appliance.
The upgrade path to Cisco IMC Supervisor, Release 2.0 depends upon your current version of Cisco IMC Supervisor. The following are the supported upgrade/migrate paths for Cisco IMC Supervisor, Release 2.0.
Note | From Release 2.0, the upgrade checks for valid target paths and will upgrade only if the upgrade path from the appliance version and target version is supported. |
Current Release |
Direct Upgrade/Migrate Supported |
Upgrade Path |
||
---|---|---|---|---|
1.0.0.0 or 1.0.0.1 |
No |
|
||
1.1.0.0 |
Yes |
2.0 . |
||
1.1.0.1 |
Yes |
2.0 |
||
1.1.0.2 |
Yes |
|
Step 1 | Set up the new Cisco IMC Supervisor 2.0 appliance. For more information, see Installing Cisco IMC Supervisor on VMware vSphere or Installing Cisco IMC Supervisor on Microsoft Hyper-V. | ||
Step 2 | Login as root
via the shelladmin console. Choose option 20.
| ||
Step 3 | Run /opt/infra/migration/performMigration.sh. | ||
Step 4 | Point it to an
existing appliance 1.1.x.x. All existing data will be imported.
| ||
Step 5 | Test the 2.0 appliance and validate the data. | ||
Step 6 | Decommission the old 1.1.x.x appliance. |