Nortel PBX Option 11 E&M トランクカードの設定例

#ADDING E&M CARD: 

!--- Building route data block. Use double digits with !--- route data block.

LD16(LOAD 16)
REQ:NEW
TYPE:RDB
CUST:0
DMOD:<RET>
ROUT:21
TKTP:TIE
ESN:<RET>

!--- All returns until ICOG prompt.

ICOG:IAO 

!--- Incoming and outgoing.

SRCH:<RET>
TRMB:<RET>
STEP:<RET>
ACOD:71
TARG:0 

!--- TGAR 0 and ENDCOST 0.

BILN:<RET>

!--- All returns until CNTL prompt.

CNTL:YES
TIMR:<RET>
SST:<RET>
NEDC:ETH

!--. Near end disconnect is set for either.

FEDC:ETH

!--- Far end disconnect is set for either.

CPDC:<RET>

!--- All returns until ALRM.

<SHIFT>****
LD21

!--- Load 21 to view RDB.

REQ:PRT
TYPE:RDB
CUST:0
ROUT:21
<SHIFT>********

!--- If you need to change from 2 wire to 4 wire cables !--- or vice versa, also change in the PBX config.

LD14

!--- Load 14 to add new trunk.

REQ:NEW
TYPE:TIE
TN:9 0

!--- Analog starts at 0, digital starts at 1.

XTRK:XEM
CUST:0
NCOS:0
RTMB:21 1
MNDN:<RET>
TGAR:0
SIGL<RET>
EMTY:TY1

!--- Depends on the cabling.

CPAD:<RET>
STRI:IMM
STR0:IMM
SUPN:<RET>
CLS:UNR DTN

!--- Class of service.

TKID:<RET>
<SHIFT>********
VIEW TRUNK.
LD20(LOAD 20)
REQ: PRT
TYPE: TRK
TN: 9 0
RTMB: 

!--- All returns until the end.

<SHIFT>********

!--- After you finish all four trunks, you must enable !--- the trunks.

LD32
STAT 9
DISC 9

!--- Disable card 9: the E&M card. 

ENLC 9

!--- Enable card 9.

<SHIFT>********

!--- To modify E&M type, operation (2 or 4 wires) !--- and signaling.

LD14

!--- Load 14 to add new trunk.

REQ:CHG
TYPE:TIE
TN:9 0

!--- Analog starts at 0, digital starts at 1.

XTRK:XEM
CUST:0
NCOS:0
RTMB:21 1
MNDN:<RET>
TGAR:0
SIGL<EM4> 

!--- EM4 For 4-wires, EAM For 2-wires.

EMTY:TY2 

!--- E&M type 2 depends on cabling.

CPAD:<RET>
STRI:WNK
STR0:WNK
SUPN:<RET>
CLS:UNR DTN

!--- Class of service

TKID:<RET>
<SHIFT>********