비동기 데이터를 터널링하는 방법

!--- On caller box - 10.1.2.3 define an IP hostname to use on the TELNET so we can use BUSY-MESSAGE to shut up TELNET.

ip host CALLED-LINE 4003 10.3.2.1          ! port 40xx is raw TCP

!--- Busy-message cannot have a null string - single space works.

busy-message CALLED-LINE \ \               [1]
service tcp-keepalives-out                 [3]
!
line 2
!--- Shut up everything.

no motd-banner                             

!--- Not available in all versions.

no exec-banner
no vacant-message
autocommand telnet CALLED-LINE  /stream
autohangup

!--- The following command means incoming serial data is saved until the TCP connection is made.


! 

no flush-at-activation

!--- Not available in all feature sets.

no activation-character                    

!--- Any character will create the EXEC.

escape-character NONE                      

!--- This can also be escape-character BREAK. 

exec                                       

!--- Need an EXEC to do the TELNET.

special-character-bits 8
exec-timeout 0 0
session-timeout 0 0

!--- RS232 configuration:

no modem inout                             

!--- Disable modem control [2]. 

no autobaud
speed 9600                                 

!--- Set the desired speed.

stopbits 1                                 

!--- Alternatively, this can be 2, as desired.

flowcontrol NONE                           

!--- Alternatively, this can be HARDWARE, or SOFTWARE.

transport input NONE                       

!--- Do not allow reverse connections.

!--- On called box - 10.3.2.1.

no banner incoming
service tcp-keepalives-in                  [3]
line 3
no exec
no exec-banner
no vacant-message

!--- RS232 configuration:

modem DTR-active 

!--- DTR indicates the status of the TCP connection.

no autobaud
speed 2400 

!--- As desired. This does not need to match the speed on the called side.

stopbits 1                                 

!--- Alternatively, this can be 2, as desired.

flowcontrol NONE                           

!--- Alternatively, this can be HARDWARE, or SOFTWARE.

transport input telnet                     

!--- Allow the incoming TCP connection.