簡介
本文檔介紹如何使用TLSVERIFY排除TLS傳遞故障。
關於思科郵件安全裝置(ESA)上的郵件處理，您可能看到TLS未傳送或返回錯誤或警報。
從裝置上的CLI，使用tlsverify測試從您的裝置到外部域的TLS通訊。
mail3.example.com> tlsverify
Enter the TLS domain to verify against:
[]> example.com
Enter the destination host to connect to. Append the port
(example.com:26) if you are not connecting on port 25:
[example.com]> mxe.example.com:25
Connecting to 1.1.1.1 on port 25.
Connected to 1.1.1.1 from interface 10.10.10.10.
Checking TLS connection.
TLS connection established: protocol TLSv1, cipher RC4-SHA.
Verifying peer certificate.
Verifying certificate common name mxe.example.com.
TLS certificate match mxe.example.com
TLS certificate verified.
TLS connection to 1.1.1.1 succeeded.
TLS successfully connected to mxe.example.com.
TLS verification completed.
tlsverify命令的上述輸出展示從此裝置到IP地址為1.1.1.1的目標裝置的TLS驗證。
相關資訊
意見