Cisco Performance Routing Engine 5 - Quick Start Guide

Available Languages

Download Options

  • PDF     (3.6 MB)
    View with Adobe Reader on a variety of devices
Updated:December 2, 2013

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Table Of Contents

Installing the PRE5


Quick Start Guide

Installing the PRE5

Before you begin installing the PRE5, you must install the foam gaskets on the LCD display panel of the Cisco uBR10012 router to meet the EMI requirements. Read the instructions in the Installing the Foam Gaskets for PRE5 section in the PRE5 Hardware Installation Guide document at:

http://www.cisco.com/en/US/docs/interfaces_modules/cable/performance_routing_engine/installation/guide/b_pre5_hig.html

1. Ensure that the ejector levers of the PRE5 are at a fully-open position.

2. Grasp the PRE5 and position it in the slot.

3. Keep the ejector levers of the PRE5 at the fully-open position, without exerting excessive force. Then slide the PRE5 into the slot, slowly.

4. Slide the PRE5 into the slot until the ends of both ejector levers touch the front panel surface of the chassis. Then, pivot both the ejector levers toward each other to firmly seat the PRE5 in the backplane.

5. Using a #2 Phillips screw driver, tighten the top and bottom captive screws to secure the PRE5.

Was this Document Helpful?

FeedbackFeedback

Contact Cisco

This Document Applies to These Products