7935 IP Conference Phone Optimal Performance Configuration

Available Languages

Download Options

PDF (7.3 KB)
View with Adobe Reader on a variety of devices

Updated:February 3, 2006

Document ID:11011

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Prerequisites

Requirements

Components Used

Conventions

Use the Current Release

Hard Set the Ethernet Port

Hard Set the Port on the Switch

Remove Voice or Auxiliary VLAN References

Related Information

Introduction

The purpose of this document is to provide you with a number of recommendations to help you achieve optimal performance from the Cisco 7935 IP Conference Phone.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on the Cisco 7935 IP Conference Phone.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Use the Current Release

For optimal performance, use the most current release of the software. The current release is:

P005W301

Hard Set the Ethernet Port

Complete these steps to hard set the Ethernet port:

Press Menu.
Use the down arrow to navigate to Admin Setup and press Select.
Enter the default passcode of **# and press the Enter softkey.
Use the down arrow to navigate to Ethernet Port Configuration and press Select.
Use the down arrow to navigate to 10 MBPS-HalfDuplex and press the Change softkey.
When prompted with The change(s) you have requested will cause the Cisco 7935 IP Conference Phone to restart. Please confirm!, press the Confirm softkey.
The phone reboots.

Hard Set the Port on the Switch

Hard set the port on the switch to which the Cisco 7935 IP Conference Phone connects to 10 Mbps/half-duplex.

Issue these commands to hard set the port on the switch for Catalyst 2900XL and 3500XL products:

configure terminal
interface 0/x
speed 10
duplex half
end

Issue these commands to hard set the port on the switch for Catalyst 4xxx, 5xxx, and 6xxx products:

set port speed x/y 10
set port duplex x/y half

Remove Voice or Auxiliary VLAN References

Since the Cisco 7935 IP Conference Phone has no 10/100 port to which to connect a PC as other 7900 Series IP Phones do, the concept of a voice or auxiliary VLAN does not directly apply and can cause problems. Remove references to the voice VLAN or auxiliary VLAN from the port on the switch that the Cisco 7935 connects to, and put that port in the VLAN whose number corresponds with that of the voice VLAN to avoid potential problems.

Issue these commands to remove voice or auxiliary VLAN references for Catalyst 2900XL and 3500XL products: