N560-RSP4 and N56-RSP4-E LEDs
LED |
Color/State |
Description |
---|---|---|
Power (PWR) |
Off |
Disabled/no power to RSP |
Green |
Power rails on RSP in range |
|
Status (STAT) |
Off |
Disabled/power down |
Red |
Failure to boot (lit at reset) |
|
Yellow |
Rommon booted |
|
Green |
IOS XR booted and running |
|
Active (ACT) |
Off |
Not available |
Yellow |
Standby (indicates standby RSP) |
|
Green |
Active (indicates active RSP) |
|
Management port (MGMT) |
Off |
No connection |
Green |
Connected with no activity |
|
Flashing green |
Connected with activity |
|
Sync status (SYNC) |
Off |
Not enabled |
Yellow |
Free run |
|
Flashing yellow |
Holdover |
|
Green |
Locked to source |
|
USB flash (MEM) |
Flashing green |
USB activity |
BITS |
Off |
Out of service/not configured |
Amber |
Fault or loop condition |
|
Green |
In frame/working properly |
The PWR and STAT LEDs are available on the front panel. These LEDs provide power on the board (PWR) and overall router health (STAT) status. During power up state, these LEDs provide booting status and report errors.
Note |
The digital code signing functionality validates the integrity and authenticity of the ROMMON image before booting it. |
The PWR and STAT LEDs are available on the front panel. These LEDs provide power on the board (PWR) and overall router health (STAT) status. During power up state, these LEDs provide booting status and report errors.
Power (PWR) LED State |
Status (STAT) LED State |
Indication |
Remarks |
---|---|---|---|
Light Green |
Red |
Power is OK and the field-programmable gate array (FPGA) is configured successfully, but FPGA image validation failed. |
Image validation failed. System is in hung state. |
Flashing Light Green and Green alternatively |
Off |
FPGA configured and core validated successfully. FPGA image passed the control to micro-loader to boot ROMMON. |
System is up with ROMMON. Both the FPGA image is validated successfully, but the booted ROMMON (primary or secondary) is undetermined. |
Amber |
The digital code signing functionality reported upgrade FPGA image validation error and is continuing with the FPGA image. |
System is up with ROMMON. FPGA image is validated successfully, but the booted ROMMON (primary or secondary) is undetermined. |
|
Red |
The digital code signing functionality reported failure in the ROMMON image validation. |
FPGA is up but both primary and secondary ROMMON failed. System is in hung state. |
|
Green |
Off |
IOS XR is successfully booted |
IOS XR writes into FPGA register to indicate that it has booted, FPGA stops flashing PWR LED and turns Green. Software now controls the STAT LED. |