Release Notes for Cisco TrustSec 3.0
General Deployability 2013 Release
The most current version of this document is available at the following URL:
http://www.cisco.com/en/US/docs/switches/lan/trustsec/release/notes/rn_cts_crossplat.html
Contents
This document contains the following sections:
•New Features, Supported Hardware and Software
•Cisco TrustSec How-To Documents
•Caveats - TrustSec 3.0 General Availability 2013 Release
•Related Documentation
New Features, Supported Hardware and Software
For a complete table of features, platforms, and IOS images supported in the TrustSec 3.0 release, see the Cisco TrustSec 3.0 Product Bulletin at the following URL:
http://www.cisco.com/en/US/netsol/ns1051/index.html
See also, the Matrix of Cisco TrustSec-Enabled Infrastructure at the following URL:
http://www.cisco.com/en/US/solutions/ns170/ns896/ns1051/trustsec_matrix.html
Cisco TrustSec How-To Documents
TrustSec "How-to" Configuration Guides are classified in the following sections:
•Section 1: Introduction, BootStrapping and Universal Configurations
•Section 2: Deployment Modes
•Section 3: Profiling, Using Cisco ISE and BYOD
•Section 4: Security Group Tagging (SGA) and More
Find all Cisco TrustSec "How-To" documents at the following URL:
http://www.cisco.com/en/US/solutions/ns340/ns414/ns742/ns744/landing_DesignZone_TrustSec.html
Caveats - TrustSec 3.0 General Availability 2013 Release
Open Caveats
Cisco Catalyst 3750-X Series Switches
Release notes for Catalyst 3750-X Series switches:
http://www.cisco.com/en/US/products/ps10745/prod_release_notes_list.html
|
|
|
|
CSCud33133 |
CTS |
15.0(2)SE |
RBACL list is requested even if SG gen-id didn't change. |
CSCud38033 |
CTS |
15.0(2)SE |
No peer policy requested when link is CTS Manual. |
Cisco Catalyst 4500 Series Switches
Release notes for Catalyst 4500 Series switches:
http://www.cisco.com/en/US/products/hw/switches/ps4324/prod_release_notes_list.html
|
|
|
|
CSCud97768 |
CTS |
IOS XE 3.3.0SG |
CTS link is not established when cts manual is set a with policy dynamic identity. |
Cisco Catalyst 6500 Series Switches
Release notes for Catalyst 6500 Series switches:
http://www.cisco.com/en/US/products/hw/switches/ps708/prod_release_notes_list.html
|
|
|
|
CSCud33412 |
CTS |
15.1(1)SY |
RBACL gen-id is not shown correctly in the show cts rbacl command. |
CSCud66895 |
CTS |
15.1(1)SY |
Authorization success counter in CTS interfaces doesn't increase as expected. |
CSCud95127 |
EAP |
15.1(1)SY |
Catalyst 6K crashes when cts change-password procedure is interrupted. |
Cisco Nexus 1000V Series Switches
Release notes for Nexus 1000V Series switches:
http://www.cisco.com/en/US/products/ps9902/prod_release_notes_list.html
|
|
|
|
CSCud06240 |
SVS |
4.2(1)SV2(1.1) |
Could not establish SXP connection after reset- FCS-security |
CSCuc94663 |
SVS |
4.2(1)SV2(1.1) |
HA installation creates confusion. |
CSCuc94677 |
SVS |
4.2(1)SV2(1.1) |
Cannot perform a switchover if using simple password and duplicated domain. |
Cisco Nexus 7000 Series Switches
Release notes for Nexus 7000 Series switches:
http://www.cisco.com/en/US/products/ps9402/prod_release_notes_list.html
|
|
|
|
CSCud28769 |
CTS |
6.1 |
IP to SGT mapping learned through SXP should be preferred to CLI configuration. |
Related Documentation
Cisco IOS Software Documentation