Installing the Power Cassette Module in the Cisco cBR Chassis
The chassis ships with the Power Cassette Module installed. You may need to install the Power Cassette Module to swap the power system of the chassis.
Before you begin
Warning |
When you install the module, the chassis ground connection must always be made first and disconnected last. Statement 1046 |
-
Be aware of the weight and size of the equipment. Handle it with care.
Required Tools and Equipment
-
3/16" flat-blade torque screwdriver
-
AC or DC Power Cassette Module
-
T10 Torx torque screwdriver
Procedure
Step 1 |
Loosen the two screws on the front power entry bezel using a 3/16" flat-blade torque screwdriver. Remove the front power entry bezel from the chassis.
|
||||
Step 2 |
Remove the four #6-32 Torx-head screws located on the chassis mounting flanges using a T10 Torx torque screwdriver. |
||||
Step 3 |
Slide the Power Cassette Module into the slot in the chassis until the mounting flanges are fully seated. |
||||
Step 4 |
Insert the four #6-32 Torx-head screws into the mounting flanges. Tighten the screws using a T10 Torx torque screwdriver with a torque of 8-10 in-lb (0.90-1.13Nm) to secure the module. |
||||
Step 5 |
Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16" flat-blade torque screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel. |