CSCvf34701
|
16.6.1 - STB gets stuck on US4 instead of being moved by RLBG
|
CSCve92604
|
DSID mismatch between SUP and LC
|
CSCvf17593
|
Part of PCMM mcast db remain while gatedelete return success
|
CSCvf25891
|
service flow created by dsg not re-created after SUPHA
|
CSCve18193
|
SID not release after change wideband bundle
|
CSCve09914
|
Stby reload automaticly when config exist ipdr-related running-config to active sup
|
CSCvf33795
|
All modems are disappeared after cdman restart in the automation
|
CSCve88453
|
Automore feature broken for 'show cable signal-quality cmts' cmd
|
CSCvf32716
|
CBR8 impacting queue drain on 3.18.1aSP
|
CSCve28505
|
cdman: US-PHY PHY6 ch:1 rx intUsProcbFlow isr
|
CSCvf26114
|
CURL: issue found in comprehensive LCHA/LCPR/SUPHA test of Scheduler enable/disable/rate CLI
|
CSCve79762
|
D3.1 CM stuck in init(o) status after DS controller profile changed or RPD-reconfig w/ auto-DCID
|
CSCvf20348
|
D3.1 US: Probes with power errors should be ignored and probes should use Adjust instead of Set TLV
|
CSCvf02250
|
ltc3882 LC errors observed with 16.5.1 FW
|
CSCve88199
|
Modems switch to lower modulation data-iuc right after LCHA for about 20 seconds
|
CSCvf18412
|
OFDMA: Max-bit-rate config for CURL stuck at 400Mbps and does not reflect other changes
|
CSCvf04299
|
Protect LC rebooting continuously after loading Operation simplification config
|
CSCve11835
|
RPHY: Controller not be consistent with ds_prof after freq alloc failed when changing qam-profile.
|
CSCvf16487
|
Upstream TCP traffic drops down for 30s before coming back
|
CSCve56192
|
With Traffic, CM US power incremental power adjustments until max power is reached
|
CSCuy48322
|
Could not set value for mib ccqmEnfRuleViolateNotifEnable with OpsConfig
|
CSCva21658
|
cbr8 - service flow state are pro for certain modems
|
CSCve73300
|
cBR8 line card reload at cmts_us_sched_flow_clear
|
CSCvf37518
|
cbr8: cdxIfUpChannelMaxUGSLastOneHour value not same after LCHA
|
CSCve53153
|
OFDM related info are still shown up even D3.1-mode disable
|
CSCve89151
|
suggest command "cable primary-sflow-qos11 keep all" follw 10k implement
|
CSCve09712
|
Traceback @ intr_stat_snapshot_and_process after SUPHA
|
CSCvf29141
|
Updates to MD-DS-SG Regenerate Freq Based Template RCCs
|
CSCve72030
|
VOIP Jitter is bigger than 5ms when configure 43 UGS with modulation profile 24
|
CSCva94951
|
Cable modem IPv6 address out-of-sync between SUP and CLC
|
CSCvf28887
|
CBR8 Misreports In/Out Octet Counters on Etherchannel Subinterfaces
|
CSCve93873
|
STM, the Penalty Duration set in configuration vs. show subscriber-usage does not matched
|
CSCve65478
|
"%HA_CONFIG_SYNC-3-LBL_CFGSYNC: Unable to sync msg printed out when system bootup
|
CSCve98122
|
After LCHA and reset rpd before new sty-lc online, all rpd can't online due to gcp fail
|
CSCvf27415
|
cBR8 "show harddisk: all:" command output incomplete/cut-off before displaying all files
|
CSCve11015
|
EDVT: HW_PFU-3-PFU_IDPROM_CORRUPT: R0/0: emd: The PEM/FM idprom could be read ...
|
CSCvd94507
|
IOSd restart after LCPR
|
CSCvb47406
|
iosd-clc or ios-db reload after line card IOSd process restart
|
CSCvf21542
|
RPHY: Pri core stuck in GCP after switch LC delete rpd
|
CSCux40403
|
Traffic loss in average of 9~10 seconds after CDMAN crash
|
CSCvf37844
|
Unexpected CRITICAL facility alarm reported for DPIC 10G ports after sup test crash
|
CSCvf05030
|
Upgrade Supervisor PSOC causes Supervisor reload
|
CSCve12127
|
"(config-rpd)#no rpd-event profile" does not work.
|
CSCvf32565
|
RPHY: RPD stuck at init(l2tp) after change identifier
|
CSCvc85337
|
Traceback@be_process_events_waiting_p when do command "cable rpd ssd all status"
|
CSCve89033
|
RPHY IPDR util did not report actually channel utilization
|
CSCve87440
|
cBR8/3.18.1aSP - Powerkey cable video session goes in fail-to-black after initial configuration
|
CSCvf20161
|
GQI announce message (5406/2104) not sent on switch to good source
|
CSCve00370
|
Multicast Source-Switch skipping some Active Sources
|
CSCvf33535
|
PSIT:Session create configs with vei_bundle getting removed on reloading cbr-8 with inactive LED
|