The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter contains the following sections:
The Cisco Network Insights Base application is pre-installed and enabled with Cisco APIC, release 4.2(4). Cisco Network Insights Base allows the application to share environment specific data with Cisco when connected and claimed in the device connector.
For details on device connector, see Setting Up the Device Connector.
This section contains the steps required to disable the Cisco Network Insights Base application enabled with Cisco APIC, release 4.2(4).
Before you begin installing a Cisco Network Insights Base application, make sure the following requirements are met:
You must have administrator credentials to disable Cisco Network Insights Base application.
| Step 1 |
Log in to the Cisco APIC GUI with admin privileges. |
| Step 2 |
Click the Apps tab on the top naviagation bar. Then click Open from the Cisco Network Insights Base application dialog. |
| Step 3 |
The Cisco Network Insights Base application dialog appears. |
| Step 4 |
Click Enable in the Cisco Network Insights Base application dialog. |
| Step 5 |
Unckeck Help Cisco Improve its products option. |
The Cisco Network Insights Base application is supported only on Cisco APIC, release 4.2(4). This application is not compatible with Cisco APIC, releases 4.0.x, 4.1.x, 4.2(1i), and 4.2(2e).
Feedback