New and Changed Information
This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS Unicast Routing Configuration Guide, Release 10.3(x).
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
Policy Based Routing: Next hop over tunnel |
Added PBR support for redirecting to next-hop over tunnel on Cisco Nexus 9000 Series platform switches. |
10.3(3)F |
|
|
PBR Default NH -Sequential Preference |
Added support for redirecting the packets that match the default route to specified Next-Hop in the policy. |
10.3(3)F |
|
|
BGP Autonomous node IP assignment for container networking |
The IPv6 Compute Node IP Auto-Configuration support is provided to assign and distribute the node IP addresses to multi-homed compute nodes and establish reachability to K8s cluster using the assigned node IP. |
10.3(3)F |
IPv6 Compute Node IP Auto-Configuration Guidelines and Limitations for IPv6 |
|
ECMP Hash key not set for ECMP routes |
Added hardware keyword to enable underlay and overlay load balancing between two different ECMP VXLAN routes. |
10.3(3)F |
|
|
Expanded support for Type-6 password encryption - BGP |
Added Type-6 encryption support for BGP user password. |
10.3(3)F |
|
|
Expanded support for Type-6 password encryption - OSPF |
Added Type-6 keychain encryption support for OSPFv2 user password. |
10.3(3)F |
|
|
PBR- Default IPv4/IPv6 nexthop VRF Selection Support |
Added support for default IPv4/IPv6 nexthop VRF selection for PBR on Cisco Nexus 9000 Series platform switches. |
10.3(2)F |
Set Criteria for Policy-Based Routing Route Map Support Matrix for Policy-Based Routing |
| UCMP Load Balancing |
This feature provides support for balancing the traffic load and for administering control over the routing behavior. |
10.3(1)F |
|
| BGP Interface-Range Peering |
This feature allows BGP to provision a group of interfaces by specifying the interface range. |
10.3(1)F |
Configuring BGP Interface Peering via IPv6 Link-Local for IPv4 and IPv6 Address Families |
| BGP Interface Peering with Multiple Instances |
This feature allows BGP to enable the maximum-peers command under the neighbor interface mode to control the number of sessions that are brought up from an interface. |
10.3(1)F |
Configuring BGP Interface Peering via IPv6 Link-Local for IPv4 and IPv6 Address Families |
|
Multi VRF support |
Multi VRF is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | Guidelines and Limitations for VRFs |
|
ECMP, 64-way |
ECMP, 64-way is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
Route leak between VRFs |
Route leak between VRFs is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
OSPF |
OSPF is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
EIGRP |
EIGRP is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
BGP |
BGP is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
IPv4 and IPv6 Static Routing |
Static routing is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
IPv4 and IPv6 Dynamic Routing |
Dynamic routing is supported on the Cisco Nexus 9808 platform switches. |
10.3(1)F | |
|
VXLAN EVPN is supported only as transit |
VXLAN EVPN is supported only as transit on Cisco Nexus 9808 platform switches. |
10.3(1)F |
|
|
Unicast consistency checker |
Added support for Unicast consistency checker on Cisco Nexus 9808 platform switches. |
10.3(1)F |
|
|
BGP Large Community |
This feature adds support to define large communities that are 12 bytes in size and provides the flexibility in classification of BGP routes. |
10.3(1)F |
Configuring NX-OS BGP Large Communities |
Feedback