New and Changed Information
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
Support tunnel interfaces |
ePBR supports IPv4 and IPv6 policies on tunnel interfaces. |
10.4(1)F |
|
|
Support for load-balancing/redirection to nodes over tunnels |
ePBR supports redirection or load-balancing to layer-3 endpoints reachable over tunnel interfaces. |
10.4(1)F |
|
|
ePBR out-of-service |
ePBR supports the ability to temporarily shutdown an endpoint, either administratively or by gracefully disabling the endpoint when a user defined failure threshold is met. |
10.4(1)F |
ePBR Service Endpoint Out-of-Service |
|
Support for port operators in ACLs |
ePBR L3 and ePBR L2 policies supports Layer-4 port operators in match access-lists. |
10.4(1)F |
|
|
User mask position load-balance configuration options​ |
ePBR supports the mask-position configuration to choose the bits used for load-balancing in user-defined ACL for IPv4 or IPv6 matches. |
10.4(1)F |
Guidelines and Limitations for ePBR L2 Configuring ePBR Service, Policy, and Associating to an Interface |
|
Minimal disruptive fail-action for ePBR Layer 2 |
ePBR L2 fail-action feature is optimized to modify only the ACEs that are currently affected by the failure of the node. |
10.4(1)F |
|
|
Support to redirect/deny 'all' packets using ePBR policy |
Added the default redirect-all configuration for the ePBR policy to allow the catch-all rules to redirect all traffic, including control packets to redirect to the egress interface. |
10.4(1)F |
Feedback