Features and Important Notes for Cisco IOS Release 15.5(2)T

This document lists the new features and important notes in Cisco IOS Release 15.5(2)T:

New and Changed Information

This section lists the new hardware and software features supported in Cisco IOS Release 15.5(2)T:

New Hardware Features Supported in Cisco IOS Release 15.5(2)T

This section describes new and changed features in Cisco IOS Release 15.5(2)T. Some features may be new to Cisco IOS Release 15.5(2)T but were released in earlier Cisco IOS software releases. Some features may have been released in earlier Cisco IOS software releases and have been changed in Cisco IOS Release 15.5(2)T. To determine if a feature is new or changed, see the feature information table at the end of the feature module for that feature. Links to feature modules are included. If a feature does not have a link to a feature module, that feature is documented only in the release notes.

New Software Features Supported in Cisco IOS Release 15.5(2)T

This section describes new and changed features in Cisco IOS Release 15.5(2)T. Some features may be new to Cisco IOS Release 15.5(2)T but were released in earlier Cisco IOS software releases. Some features may have been released in earlier Cisco IOS software releases and have been changed in Cisco IOS Release 15.5(2)T. Links to feature modules are included. If a feature listed does not have a link to a feature module, that feature is documented only in the release notes.

MIBs

To locate and download MIBs for selected platforms, Cisco IOS releases, and feature sets, use the Cisco MIB Locator found at the following URL:

http://tools.cisco.com/ITDIT/MIBS/servlet/index

If the Cisco MIB Locator does not support the MIB information that you need, you can obtain a list of supported MIBs and download MIBs from the Cisco MIBs page at the following URL:

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

To access the Cisco MIB Locator, you must have an account on Cisco.com. If you have forgotten or lost your account information, send a blank e-mail to cco-locksmith@cisco.com. An automatic check will verify that your e-mail address is registered with Cisco.com. If the check is successful, account details with a new random password will be e-mailed to you. Qualified users can establish an account on Cisco.com by following the directions found at this URL:

http://tools.cisco.com/RPF/register/register.do

Important Notes

The following sections contain important notes about Cisco IOS Release 15.5M&T:

Logging into the Embedded AP and Etherswitch Modules

Starting from Cisco IOS Release 15.5(03)M06, you must configure the transport input all command under line configuration mode to log in to the embedded AP and Etherswitch modules.