- Using Ethernet Operations Administration and Maintenance
- Configuring IEEE Standard-Compliant Ethernet CFM in a Service Provider Network
- Configuring ITU-T Y.1731 Fault Management Functions in IEEE CFM
- CFM CCM Extensions to Support the NSN Microwave 1+1 Hot Standby Protocol
- IEEE-Compliant CFM MIB
- Configuring Ethernet Connectivity Fault Management in a Service Provider Network
- Ethernet Performance Monitoring on Untagged EFPs
- Syslog Support for Ethernet Connectivity Fault Management
- Dynamic Ethernet Service Activation
- Layer 2 Access Control Lists on EVCs
- Static MAC Address Support on Service Instances and Pseudowires
- IEEE 802.1s on Bridge Domains
- IEEE 802.1ah on Provider Backbone Bridges
- Enabling Ethernet Local Management Interface
- Configuring Remote Port Shutdown
- Configuring Ethernet Local Management Interface at a Provider Edge
- Configuring IEEE 802.3ad Link Bundling and Load Balancing
- Multichassis LACP
- ICCP Multichassis VLAN Redundancy
- ITU-T G.8032 Ethernet Ring Protection Switching
- Configuring IP SLAs Metro-Ethernet 3.0 (ITU-T Y.1731) Operations
- IPSLA Y1731 On-Demand and Concurrent Operations
Notes
The Cisco software feature documentation in this configuration guide often includes information about features that are shared across software releases and platforms. This guide may contain information that is not specific to your particular platform or is not supported in your software release. Additionally, some configuration guides contain content that may be superseded by documentation from a later software release.
For the latest feature information and caveats, see the release notes for your platform and software release. Additionally, use Cisco Feature Navigator to find information about feature, platform, and software image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn.
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.
Recommended Reading:
Related Documentation:
- Cisco IOS Master Command List, All Releases
- Cisco Product Selection web page (for navigating to related release-specific documentation).
Feedback