The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This appendix provides samples of control message packet captures and session states. The following topics are included:
Enter the following command to view session states.
Cisco_nas#: show subsc sess all
Figure 1 shows output for the show subscriber sessions all command.
Figure 1 Show subscriber sessions command output
This section shows an example of a policy directive set up to capture specified packets. It includes the show command you can use to display the results of the packet capture.
This section includes the following topics:
•Policy Directive Packet Capture
•Policy Directive Resulting State
Policy Directive Packet Capture
Figure 2 shows the policy directive packet capture configuration.
Figure 2 Policy Directive Packet Capture Configuration
Policy Directive Resulting State
Enter the following command to view session states for the policy directive packet capture output results.
Cisco_nas#: show subsc sess all
Figure 3 shows output for this command.
Figure 3 Policy Directive Packet Capture Output Results
This section shows an example of a service activation setup to capture specified packets. It includes the show command you can use to display the results of the packet capture.
This section includes the following topics:
•Service Activation Packet Capture
•Service Activation Resulting State
Service Activation Packet Capture
Figure 4 shows the service activation packet capture configuration.
Figure 4 Service Activation Packet Capture Configuration
Service Activation Resulting State
Enter the following command to view session states for the service activation packet capture output:
Cisco_nas#: show subsc sess all
Figure 5 shows output for this command.
Figure 5 Service Activation Packet Capture Output
This section shows an example of a service deactivation set up to capture specified packets. It includes the show command you can use to display the results of the packet capture.
This section includes the following topics:
•Service Deactivation Packet Capture
•Service Deactivation Resulting State
Service Deactivation Packet Capture
Figure 6 shows the service deactivation packet capture configuration.
Figure 6 Service Deactivation Packet capture configuration
Service Deactivation Resulting State
Enter the following command to view session states for the service activation packet capture output:
Cisco_nas#: show subsc sess all
Figure 7 shows output for this command.
Figure 7 Service Deactivation Packet Capture Output
This section shows an example of a service disconnect setup to capture specified packets.
Figure 8 shows the service disconnect packet capture configuration.
Figure 8 Service Disconnect Packet Capture Configuration