Skip to content
Skip to search
Skip to footer

Interface and Hardware Component Configuration Guide for Cisco 8000 Series Routers, IOS XR Release 24.1.x, 24.2.x, 24.3.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: November 1, 2024

Chapter: New and Changed Feature Information

New and Changed Feature Information
Interface and Hardware Component Features Added or Modified in IOS XR Release 24.x.x

New and Changed Feature Information

This table summarizes the new and changed feature information for the Interfaces Configuration Guide for Cisco 8000 Series Routers for Cisco 8000 Series Routers, and tells you where they are documented.

Interface and Hardware Component Features Added or Modified in IOS XR Release 24.x.x

This table summarizes the new and changed feature information for the Interfaces Configuration Guide for Cisco 8000 Series Routers for Cisco 8000 Series Routers, and tells you where they are documented.

Table 1. New and Changed Features
Feature	Description	Introduced in Release	Where Documented
Remote Link State Propagation	This feature was introduced.	Release 24.3.1	Remote Link State Propagation
Media Link-down Prefec Degrade Enablement	This feature was introduced.	Release 24.3.1	Media Link-down Prefec Degrade Enablement
Untagged L2 Subinterface	This feature was introduced.	Release 24.2.11	Untagged L2 Subinterface
Default Carrier Delay on Physical Interfaces	This feature was introduced.	Release 24.2.11	Setting the Carrier Delay on Physical Interfaces
Mirroring Buffer Drop Packets	This feature was introduced.	Release 24.2.11	Mirroring Buffer Drop Packets
Monitoring Layer 3 Connectivity Using Down MEP on L3 Interfaces	This feature was introduced.	Release 24.2.11	Ethernet CFM
User-Defined Fields for ECMP Hashing	This feature was introduced.	Release 24.2.11	User-Defined Fields for ECMP Hashing
QDD Optical Line System	This feature was introduced.	Release 24.1.1	Configuring QDD Optical Line System
Configurable FDD and FED Alarm Threshold Values	This feature was introduced.	Release 24.1.1	Configuring FEC Alarm Threshold
View Additional Alarms for Coherent Optical Transceiver	This feature was introduced.	Release 24.1.1	Display of Alarms for Coherent Optical Transceivers
View Coherent Optical Transceiver Module Parameters	This feature was introduced.	Release 24.1.1	View Coherent Optical Transceiver Module Parameters
Generic UDP Decapsulation for IPv6 Traffic	This feature was introduced.	Release 24.1.1	Configure GUE
Extended Support for DP04QSDD-HE0 Optical Module	This feature was introduced.	Release 24.1.1	Configuring 400G Digital Coherent Optics
Enhanced Alarm Prioritization, Monitoring, and Management	This feature was introduced.	Release 24.1.1	Alarms Troubleshooting

Was this Document Helpful?

Feedback

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)