Skip to content
Skip to search
Skip to footer

Interface and Hardware Component Configuration Guide for Cisco 8000 Series Routers, IOS XR Release 7.5.x

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: September 29, 2023

Chapter: New and Changed Feature Information

New and Changed Feature Information
Interface and Hardware Component Features Added or Modified in IOS XR Release 7.5.x

New and Changed Feature Information

This table summarizes the new and changed feature information for the Interfaces Configuration Guide for Cisco 8000 Series Routers for Cisco 8000 Series Routers, and tells you where they are documented.

Interface and Hardware Component Features Added or Modified in IOS XR Release 7.5.x

This table summarizes the new and changed feature information for the Interfaces Configuration Guide for Cisco 8000 Series Routers for Cisco 8000 Series Routers, and tells you where they are documented.

Table 1. New and Changed Features
Feature	Description	Introduced in Release	Where Documented
User-Defined Fields for ECMP Hashing	This feature was introduced.	Release 7.5.5	User-Defined Fields for ECMP Hashing
Diagnostic Parameters for Optical Transceivers	This feature was introduced.	Release 7.5.5	Diagnostic Parameters for Optical Transceivers
Loopback on Optical Transceivers	This feature was introduced.	Release 7.5.5	Loopback on Optical Transceivers
Traffic Mirroring with DSCP	This feature was introduced.	Release 7.5.4	Traffic Mirroring with DSCP
Instant Display of Traffic Rates for all the Physical Interfaces	This feature was introduced.	Release 7.5.4	Viewing Interface Counters Report
Configure Tunnel Destination with an Object Group	This feature was introduced.	Release 7.5.4	Configure Tunnel Destination with an Object Group
Specifying User-Defined LLDP TLV Values	This feature was introduced.	Release 7.5.3	Specifying User-Defined LLDP TLV Values
Partial Packet Capture Ability for ERSPAN (RX)	This feature was introduced.	Release 7.5.3	Partial Packet Capture Ability for ERSPAN (RX)
SPAN to File Support for TX and RX	This feature was introduced.	Release 7.5.3	SPAN to File Support for TX and RX
Partial Packet Capture Ability for SPAN to File (RX)	This feature was introduced.	Release 7.5.3	Partial Packet Capture Ability for SPAN-to-File (RX)
Ethernet Frame Delay Measurement for L2VPN Services	This feature was introduced.	Release 7.5.3	Ethernet Frame Delay Measurement for L2VPN Services
ERSPAN Traffic to a Destination in a Non-Default VRF	This feature was introduced.	Release 7.5.2	ERSPAN Traffic to a Destination in a Non-Default VRF
IP MTU	This feature was introduced.	Release 7.5.2	IP MTU

Was this Document Helpful?

Feedback

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)