Cisco NCS 5500 Product Overview

Cisco NCS 5500 system is a high fault-resilient platform, which provides next generation data-center switching environment with high bandwidth and low latency.

Cisco NCS 5500 system provides:

  • A modular router with a centralized route processor with multiple line card per chassis.

  • High density, high performance, and merchant silicon-based line cards.

  • IP and MPLS switching at a low cost per 100G.

  • Label Switched Router (LSR) and possible Light Label switched Edge Router (LER) features and functionality with limited hardware scale and software functionality.

Cisco NCS 5500 Product Overview

Cisco NCS 5500 system is a high fault-resilient platform, which provides next generation data-center switching environment with high bandwidth and low latency.

Cisco NCS 5500 system provides:

  • A modular router with a centralized route processor with multiple line card per chassis.

  • High density, high performance, and merchant silicon-based line cards.

  • IP and MPLS switching at a low cost per 100G.

  • Label Switched Router (LSR) and possible Light Label switched Edge Router (LER) features and functionality with limited hardware scale and software functionality.

Command Modes

The router runs on virtualized Cisco IOS XR software. Therefore, the CLI commands must be executed on virtual machines, namely the XR LXC and the System Admin LXC.

The command modes are applicable for the Cisco NCS 5500 Series Routers. This table lists the command modes for the LXCs.

Command Mode Description

XR EXEC mode

(XR LXC execution mode)

Run commands on the XR LXC to display the operational state of the router.

Example: 
RP/0/RP0/CPU0:router#

XR Config mode

(XR LXC configuration mode)

Perform security, routing, and other XR feature configurations on the XR LXC.

Example: 
RP/0/RP0/CPU0:router#configure 
RP/0/RP0/CPU0:router(config)#

System Admin EXEC mode

(System Admin LXC execution mode)

Run commands on the System Admin LXC to display and monitor the operational state of the router hardware. The chassis or individual hardware modules can be reloaded from this mode.

Example: 
RP/0/RP0/CPU0:router#admin 
sysadmin-vm:0_RP0#

System Admin Config mode

(System Admin LXCconfiguration mode)

Run configuration commands on the System Admin LXC to manage and operate the hardware modules of the entire chassis.

Example: 
RP/0/RP0/CPU0:router#admin 
sysadmin-vm:0_RP0#config 
sysadmin-vm:0_RP0(config)#