New and Changed VPN Features
|
Feature |
Description |
Changed in Release |
Where Documented |
|---|---|---|---|
|
Ethernet Data Plane Loopback |
The Ethernet Data Plane Loopback feature provides a means for remotely testing the throughput of an Ethernet port. |
Release 6.3.1 |
|
|
Ethernet Local Management Interface (E-LMI) |
The Cisco NCS 5500 Series Router supports the Ethernet Local Management Interface (E-LMI) protocol as defined by the Metro Ethernet Forum, Technical Specification MEF 16, Ethernet Local Management Interface (E-LMI), January 2006 standard. |
Release 6.3.1 |
|
|
L2CP Tunneling |
Layer 2 Control Protocol Tunneling (L2PT) is a Cisco proprietary protocol for tunneling Ethernet protocol frames across layer 2 switching domains. The system supports the following tunnel protocols: |
Release 6.3.1 |
|
|
EVPN IPv6 Hosts with Mobility |
EVPN IPv6 Hosts with Mobility feature enables you to provide EVPN IPv6 service over IPv4-MPLS core network. |
Release 6.3.2 |
|
|
EVPN Multiple Services per Ethernet Segment |
EVPN Multiple Services per Ethernet Segment (ES) feature allows you to configure multiple services over single ES. |
Release 6.3.2 |
|
|
EVPN VPWS On Demand Next Hop with SR-TE |
The EVPN VPWS On-Demand Next Hop with SR-TE feature enables you to fetch the best path to send traffic from the source to destination in a point-to-point service using IOS XR Traffic Controller (XTC). |
Release 6.3.2 |
|
|
EVPN VPWS Preferred Path over SR-TE Policy |
EVPN VPWS Preferred Path over SR-TE Policy feature allows you to set the preferred path between the two end points for EVPN VPWS pseudowire (PW) using SR-TE policy. |
Release 6.3.2 |
|
|
L2VPN VPLS or VPWS Preferred Path over SR-TE Policy |
L2VPN VPLS or VPWS Preferred Path over SR-TE Policy feature allows you to set the preferred path between the two end-points for L2VPN Virtual Private LAN Service (VPLS) or Virtual Private Wire Service (VPWS) using SR-TE policy. |
Release 6.3.2 |
Feedback