application install
|
Installs a specific
application bundle.
|
application start
|
Starts or enables a specific
application.
|
application stop
|
Stops or disables a specific
application.
|
application upgrade
|
Upgrades a specific
application bundle.
|
backup
|
Performs a backup and places
the backup in a repository.
|
backup-logs
|
Performs a backup of all of
the logs on the
to a remote location.
|
banner
|
Sets messages while logging in to CLI (pre-login).
|
clock
|
Sets the system clock on the
server.
|
configure
|
Enters configuration mode.
|
copy
|
Copies any file from a source
to a destination.
|
debug
|
Displays any errors or events
for various command situations; for example, backup and restore, configuration,
copy, resource locking, file transfer, and user management.
|
delete
|
Deletes a file in the
server.
|
dir
|
Lists the files in the
server.
|
exit
|
Disconnects the encrypted
session with a remote system. Exits from the current command mode to the
previous command mode.
|
forceout
|
Forces the logout of all of
the sessions of a specific
server system user.
|
halt
|
Disables or shuts down the
server.
|
lms
|
Migrates data from LMS server to PI server.
|
mkdir
|
Creates a new directory.
|
ncs
|
NCS-related commands used to
start, stop and back up the server.
|
nslookup
|
Queries the IPv4 address or
hostname of a remote system.
|
ocsp
|
Enables certificate-based authentication for web clients using OCSP responders.
|
patch
|
Installs System or
Application patch.
|
ping
|
Determines the IPv4 network
connectivity to a remote system.
|
ping6
|
Determines the IPv6 network
connectivity to a remote system.
|
reload
|
Reboots the
server.
|
restore
|
Restores a previous backup.
|
rmdir
|
Removes an existing
directory.
|
rsakey
|
Displays a configured RSA key or sets a new RSA public key for user authentication.
|
|
|
|
|
show
|
Provides information about
the
server.
|
ssh
|
Starts an encrypted session
with a remote system.
|
tech
|
Provides Cisco Technical
Assistance Center (TAC) commands.
|
telnet
|
Establishes a Telnet
connection to a remote system.
|
terminal length
|
Sets terminal line
parameters.
|
terminal session-timeout
|
Sets the inactivity timeout
for all terminal sessions.
|
terminal session-welcome
|
Sets the welcome message on
the system for all terminal sessions.
|
terminal terminal-type
|
Specifies the type of
terminal connected to the current line of the current session.
|
traceroute
|
Traces the route of a
remote IP address.
|
undebug
|
Disables the output
(display of errors or events) of the
debug command for various command situations; for
example, backup and restore, configuration, copy, resource locking, file
transfer, and user management.
|
write
|
Erases the startup
configuration that forces to run the setup utility and prompt the network
configuration, copies the running configuration to the startup configuration,
and displays the running configuration on the console.
|