1.
Choose
Resource Management > Managed Resources > root >
tenant.
2.
In the Network Services tab, choose Add
Edge Firewall.
3.
In the
Properties screen, provide the information described in
Properties Screen, and then click
Next.
4.
In the Service
Device screen, do one of the following, and then click
Next:
- To assign an existing
ASA 1000V service device:
-
Click
Assign ASA 1000V.
-
From the
ASA 1000V Device drop-down list, choose the required
ASA 1000V.
- To instantiate a new
ASA 1000V:
-
Click
Instantiate.
-
Choose the image to use to instantiate a new
ASA 1000V service device.
-
In the
VM Access password fields, enter the password for the admin user account.
5.
(Instantiate
option only) If you instantiate a
ASA 1000V service device from an image, do one
or both of the following in the Placement screen, and then click
Next:
- Navigate to and choose the
host or resource pool to use for the
ASA 1000V instance.
- If you enabled high
availability, either check the
Same
as Primary check box, or navigate to and choose the host or
resource pool to use for the secondary
ASA 1000V instance.
6.
In the
Interfaces screen, add the required interfaces as follows, and then click
Next:
- If you assigned an
ASA 1000V without high availability, configure
one inside and one outside interface.
- If you assigned an
ASA 1000V with high availability, configure
one inside and one outside interface, each with a secondary IP address.
- If you instantiated an
ASA 1000V without high availability, configure
management, inside, and outside interfaces.
- If you instantiated an
ASA 1000V with high availability, configure
management, inside, outside, and HA interfaces.
Note
| The
management and HA interfaces must use different port profiles.
|
7.
In the Summary
screen, confirm that the information is accurate, and then click
Finish.
8.
If you
instantiated the
ASA 1000V from a service image, you must do
the following to ensure registration with
Prime Network Services Controller: