Cisco WAE Modeling Daemon (WMD) Configuration

The Cisco WMD provides a real-time network model in memory. DARE receives network changes (from NIMOs) and sends a patch with these changes to Cisco WMD. For more information on how Cisco WMD and DARE works, see the Overview chapter.


Note

Data that is not available/up to date in WMD is listed in <run-directory>/packages/cisco-wae-modeling-daemon/priv/etc/sql-patch-config.txt under the headings IgnoredTables and IgnoredColumns.

To configure DARE and WMD, see the following topics:

Configure the WAE Modeling Daemon (WMD)

WMD provides a near real-time representation (model) of the network in memory so that applications can get access to that model. It gets changes from SAgE.

This procedure describes how to configure WMD using the Expert Mode. However, you can also configure WMD using the WAE UI. From Cisco WAE UI, click WMD Configuration and use the information below to configure WMD. Click Save to save the configuration.

Before you begin

The following information should be on hand or configured:

  • Final network model name

  • Design RPC

Procedure

Step 1

From the Expert Mode, in Configuration editor, navigate to /wae:wae/components/wmd:wmd and click config.

Step 2

From the network-name drop-down list, select the final network model.

Step 3

Select Enable button to enable WMD.

Step 4

Click rpc-connection and enter Design RPC values.

Step 5

Click app-subscriber-connections and enter host and port information for all automation application connections.

Step 6

Click dare and enter the following values.

  • dare-destination—Select the DARE network.
  • connection-attempts—Enter the number of times to try to reconnect until the connection is reestablished.
  • connection-retry-delay—Enter the interval (in seconds) between connection attempts.

Example

WAE CLI (in config mode) example:
# wae components wmd config network-name <final_model_name> dare dare-destination <dare_model_name>