New and Changed Information
See Data Models Configuration Guide for Cisco NCS 1004 and Telemetry Configuration Guide for Cisco NCS 1000 Series to refer the other configuration guides of NCS 1004.
This table summarizes new and changed information for configuration guide for Release 7.1.1, and lists where the features are documented.
|
Feature |
Description |
Where Documented |
|---|---|---|
|
Fault Profiles |
The Fault Profiling feature enables the user to create a unique fault profile for faults on the system or the line card. Each fault profile can contain one or more faults with user-defined severities. |
|
|
Air Filter |
The air filter removes dust from the air drawn into the chassisby the fan units. If the air filters are damaged,dirty, or clogged with dust, they must be replaced with a new air filter. Cisco NCS 1004 air filter has the following components:
|
|
|
Sub 50G configuration |
The sub 50G or coupled mode can be configured on the 1.2T card only in the muxponder mode. The supported trunk data rates are 150G, 250G, 350G, 450G, and 550G. |
|
|
Remote Node Management Using GCC |
The remote node management feature allows the user to remotely manage the NCS 1004 nodes over the General Communication Channel (GCC) interface. The remote nodes that are not connected to the management network over the Ethernet interface can be managed over the GCC interface. This feature supports remote management of up to eight nodes in hub topology and up to two nodes in linear topology. GCC2 and GCC0 are supported in NCS 1004. |
|
|
Regeneration Mode |
The 1.2T card can be configured in Regeneration (regen) mode. In regen mode, only trunk optics Controller and CoherentDSP controllers are created. |
|
|
PRBS |
Pseudo Random Binary Sequence (PRBS) feature enables you to perform data integrity checks between the NCS1004 trunk links without enabling the actual client traffic. |
|
|
Ethernet Statistics |
The ethernet statistics are displayed for the current and historical performance monitoring parameters of ethernet controller in 30 second intervals. |
|
|
LLDP on Management Port |
LLDP support on management interface feature requires a system to form LLDP neighborship over the system management interface, through which it advertises and learns LLDP neighbor information. This information about neighbors can be used to learn about the neighbors and in turn the topology of the devices for Operations, Administration, and Maintenance (OAM) purposes. |
Link Layer Discovery Protocol (LLDP) Support on Management Interface |
|
Open Config Enhancements |
CLI Over NETCONF A new yang model, Cisco-IOS-XR-cli-cfg.yang is defined, which consists of a leaf node called 'cli'. The leaf node can be used to either send or receive the CLI configurations. OpenConfig Terminal Device This is a terminal optics device model for managing the terminal systems (client and line side) in a DWDM transport network. Ethernet Statistics Addition The user can configure and view the performance monitoring parameters for the Optics, Ethernet, and coherent DSP controllers. |
Feedback