Cisco Catalyst 8000V Edge Software Deployment Guide for Google Cloud Platform

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: August 22, 2023

Chapter: Configuring a Sample Feature

Configuring a Sample Feature

Configuring a Sample Feature

After you deploy Cisco Catalyst 8000V in GCP and access the CLI, you can configure the supported features. In this section, the following code sample shows how to configure an IPsec VPN on a Cisco Catalyst 8000V instance running on GCP.


crypto isakmp policy 1
 encr aes
 hash sha256
 authentication pre-share
 group 14
crypto isakmp key cisco123 address 0.0.0.0        
crypto ipsec transform-set T1 esp-3des esp-md5-hmac 
 mode transport
crypto ipsec profile P1
 set transform-set T1 
interface Tunnel0
 ip address 10.0.0.2 255.255.255.0
 tunnel source GigabitEthernet1
 tunnel mode ipsec ipv4
 tunnel destination 198.51.100.253
 tunnel protection ipsec profile P1
end

ip route 6.6.6.6 255.255.255.255 Tunnel0

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)